ここから本文です
TWO:
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:By this treaty almost everything was given up which had kept Spain and Austria in war and conflict for many years, and by themselves and their allies had steeped Europe in blood. The King of Spain agreed to sanction the Ostend Company, to yield the long-contested point regarding the exclusive mastership of the Golden Fleece. He surrendered the right to garrison with Spanish troops the fortresses of Tuscany. He acknowledged the Emperor's right to Naples, Sicily, the Milanese, and Netherlands, and guaranteed what was termed the Pragmatic Sanction; that is, the succession of the hereditary states of Austria in the female line. This was a concession of immense importance to the Emperor, who had only daughters, and whose claim to the Flemish and Italian dominions might thus have been contested by Philip on the Emperor's death. Thus, before the emotions of a family quarrel, fell at once all the mighty questions which had rent and desolated Europe for a quarter of a century! Both the sovereigns engaged to afford mutual support should either be attacked. Charles agreed to bring into the field twenty thousand foot and ten thousand horse, Philip twenty thousand troops and fifteen ships of war.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:The major told him a little reluctantly. "Well, it's this, then: Brewster will not, or cannot, defend your conduct in the matter of the San Tomaso volunteers."
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:All right, Larry, let that go. But why did Jeff bring us here?

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:It was slack. That told his feverishly acute intelligence that it was the cable whose lever did not operate. He had seen that Jeff, when he flung the stick forward to try to free it, had been able to pull it back again without operating the elevators.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.